|
Item category DMM`s Clamp On AC/DC
|
 Fluke 31/33 Clamp Meters -------------------------------------------------------- The Clamp Meter of Choice for Adjustable Speed Drive Measurements, with True-rms Crest and Frequency Measurement The Fluke 31 and 33 give accurate True-rms current measurements from 0.3 to 700A max. In addition, the Model 33 captures peak values, up to 1000A, for Crest Factor calculation. Both models measure frequency, so you can use them to determine the output frequency of adjustable speed drives, to set the governor of an engine generator or to detect third harmonic currents (180 Hz) in the neutral of a 3-phase system. The Fluke 31 and 33 are built extra strong to withstand job site abuse. Why True-rms? Electrical professionals today need current clamps that are up to the challenge of accurately measuring harmonic currents caused by non-linear loads. Virtually all electronic equipment falls into this category - PCs, printers, HID lighting, adjustable speed drives, etc. Average-sensing meters can't do the job. They can produce readings that are 30%-50% low. Why? Harmonics cause distorted waveforms, and average-sensing meters can only accurately measure pure sine waves. One measure of waveform distortion is Crest Factor, the ratio of the peak to the rms value of the wave. CF for a pure sine wave is 1.4. Higher CF indicates harmonic currents. Fluke's true-rms Current Masters (Models 32, 31, 33, 36) give correct readings for any wave shape, within the instrument's CF specifications. Features True-rms ac current measurement Frequency Min/Max records maximum, minimum and average RMS current or frequency values for over 24 hours (Fluke 33 only) Auto/Manual Ranging Crest measurement of the peak of the current waveform. Used to determine Crest Factor which can indicate the presence of harmonics. (Fluke 33 only) SmoothingT displays a 3 second running average of current or frequency. (Fluke 33 only) Tapered jaws can handle 2 parallel 500 MCM cables, or a single cable, up to 38 mm (1.5") in diameter Combination Digital/Analog display; Fast analog bar graph shows surge currents Audible beep confirms key presses and, in the Model 33, indicates new highs or lows in Min/Max mode Power-up self-test - verifies proper functioning and estimates battery life Clip-on holster Sleep Mode to preserve battery life CAT III 600V ------------------------------------------------------------ CLICK HERE FOR SPECIFICATIONS AND ACCESSORIES
© 2006 Omni Controls, Inc.. All Rights Reserved. Email: Sales@Omnicontrols.com We guarantee a 24 hour response on all inquiries made via email. For quicker response please call Omni Controls at any of the above numbers |